3600 Series Transducer Mount Rebuild Kit3600 Series Transducer Mount Rebuild Kit Hardware kit for rebuilding the two joints of our 3600 Series Transducer Mounts Overtime, and especially if fishing in dirty muddy water, grit may work its way into the interior of the joints of the Transducer Mount and causing the joints to stiffen up and needing cleaned or rebuilt. This kit includes everything you need to rebuild the main pivoting angle joint plus the lower twist joint. Please select from the

These boards will allow the use of a 1" long mounting screws (available on our website also

An installer can use 3M5200 or similar BUT Pure silicone has much better sealing properties and adheres perfectly to the HDPE for a life long leak free installation

100% pure silicone or Black RTV silicone AND tape (electrical

Forward & Scout) without the use of tools or knobs to fool around with

Infinite angle adjust- ability

The piece of PVC pole in the photos below are just for demonstration and does not come with the mount

*****The "Connecting Rods" for Sliding Shaft Motors will NOT work with the MinnKota Terrova's or Ulterra's with "Lift Assist" or "Self Deployment"

Clevis Pins and Cable Management Straps are no longer supplied with mounts

be/SUDYePeVic0

v=kLh3D9oM6-k&list=UUIAsVLjRhVsBqaestPIG-hQ&index=22

25" from the center of the Sport Track

The Adapters are an alternative to RTL3650 Pole Mount sleeves and do not require the additional drilling jig in order to drill your pole mount shaft