Fibre-reinforced plastics. Methods of producing test plates - Contact and spray-up moulding1 Scope This part of ISO 1268 specifies methods for preparing reinforced plastics test plates either by contact moulding or by spray up moulding. It applies exclusively to glass reinforcements. It is intended to be read in conjunction with ISO 1268 1.

Annex D (informative) Stakeholder impact analysis

Who is BS 3338-7 – Tin and tin alloys for

All of the potential hazards that may create an unsafe garment are not covered in this standard

latent image information applied onto 35 mm colour-print film

screws bolts and nuts

BS 7907:2007 also gives recommendations on safety aspects of the packaging and display of children’s clothing

strip and plate obtained by cold-rolling

or the deliberate differentiation between types of electromagnetic environments relevant to the equipment in BS EN IEC 61326-3-2

This International Standard specifies the conditions for interchangeability

Note: Determining the method of information acquisition and specifying exactly how other undefined

CEN/TR 15353 considers the general environmental aspects that are specific to the recycling process

Instrument cabling