Petroleum and natural gas industries. Classification and conformity assessment of products, processes and services1 Scope This Technical Report describes: two classification methods (one based on calculated risk, the other on judgement of risk) which may be used to determine the appropriate conformity assessment system for products, processes and services; a set of five conformity assessment systems from which the most suitable is chosen when conformity assessment of products, processes and services is required. NOTE Alternative classification models may be used

especially fragile loads

areas and buildings

other than electrical steels and soft ferrites

BS EN 12522-1

environmental hazards

The revised standards also include updated references to normative and supporting standards

The system will not take any automatic action to prevent possible lane departures

BS EN 13848‑1 provides definitions for the principal track geometry parameters and specifies minimum requirements for measurement and the analysis methods

wire feeders

Note: BS 7063 excludes amplifiers and loudspeakers

BS EN 15512 specifies the structural design requirements applicable to all types of adjustable beam pallet rack systems fabricated from steel members intended for the storage of unit loads and subject to predominantly static loads

which in turn are used in products like adhesives