B&M Hi-Tek Aluminum Differential Cover for GM 8.875-inch 12-bolt TruckOur engineers designed the line of Hi Tek differential covers to not only look good but address a number of weaknesses of the factory stamped steel covers. First, they started by constructing the covers of thick A356. 0 T6 aluminum, which dissipates heat much faster than the factory steel unit keeping the fluid temperature lower under high stress loads vs. a steel cover. Then for added durability, we added a reinforced center bar for extra strength

Full synthetic with PAO and Ester base stocks and 2200 ppm of ZDDP for anti wear

It provides an in and out port for installing a oil cooler in almost any application

BMR Suspension designed the TCA061 to work well in street performance

Constructed from 304 stainless steel

14" long sump holds 10 quarts of oil

The BMR Rear Strut Tower Brace is constructed from lightweight DOM steel tubing and laser cut 3/l6-inch steel plate to provide maximum strength without adding unnecessary bulk

2 EA NEW GM Upper Strut Mounts

a trans-brake

7995-102 - Thrust Bearing Kit

Elite Series and Elite II valve covers

Your Bronco can encounter rocks and other debris during off-roading

return and vent ports