Pulps. Standard tap water for drainability measurements. Conductivity 40 mS/m to 150 mS/m1 Scope This International Standard describes the specification and preparation of standard tap water, of conductivity between 40 mS m and 150 mS m, for drainability measurements. This International Standard is applicable to all kinds of pulps. NOTE ISO 14487[1] describes the specification and preparation of standard distilled deionized water.

ISO 19277 describes various corrosion under insulation (CUI) environments in refineries and other related industries and environments and establishes CUI environmental categories including operating temperature ranges from −45 °C to 204 °C for topside and aboveground service only

It is not applicable to instruments with kinetic energy scale errors significantly non-linear with energy

NOTE 1 In Clause 3 of this standard

Why should you use BS 5752-2-Determination of moisture content in green coffee

From the tensile modulus in particular conditions of temperature and load duration

product management operation and product management support process areas with the guidance of a set of tools and methods capabilities for supporting tasks for product line product management

this document employs a methodology based on the categorization of structures according to specific design criteria and specified behaviours under fault conditions

BS EN 14702‑3 characterizes a test that can be easily performed and has widespread use in routine process control for sludge quality comparison in settling tanks

retests and rounding of results

is intended for application to metallic and non-metallic surfaces to give protection against corrosion and resistance to aircraft fluids and to offer surface appearance in terms of colour and level of gloss as specified by the purchaser

category A: Aerial (above ground) environment

ductile product and is normally associated with the recrystallization of the material