Shell mill holder SK 30 - 32 - 50Application: For mounting milling cutters with transversal groove. Note: d = 40 d = 60: For large diameter face mill cutters with four additional threaded holes according to DIN 2079. SK 30 without coolant exit bores on the end faceDelivery: With drivers, cross head retaining screw and cylinder head retaining screw for cutters with central coolant. For d = 60 only with four fi xation screws according to DIN 912. All holders are made of forged steel

With built-in tightening bolt

Axial sealed with two O-rings

- carbide tipped probe Ø 2 mm

clamping depth 2 mm

Positionier- und Halte-Pin

- Tightness of the screw connection tested up to 80 bar

Torque range : 20-110 Nm

Satin chrome finished

Tool steel

Measuring surfaces are carbide

E1= 14 pieces

For collets KPS-system