Hot rolled products of structural steels - Technical delivery conditions for normalized/normalized rolled weldable fine grain structural steelsThis document, in addition to part 1, specifies requirements for flat and long products of hot rolled weldable fine grain structural steels in the normalized normalized rolled delivery condition in the grades and qualities to chemical composition and mechanical properties. In addition to EN 10025 1: 2004 the steels specified in this document are especially intended for use in heavily loaded parts of welded structures such as, bridges, flood gates,

and organizations based on life cycle assessment (LCA)

there is a simultaneous push for lower weight and higher temperature resistance for better fuel efficiency

Railway applications

allocation of requirements

Power efficiency (disc friction)

BS EN 12020-1:2008 Aluminium and aluminium alloys

For equipment not built to IEC 60601-1 these requirements may be used taking into account the safety standards for the design and information in the instructions for use of that equipment

BS EN 10311 specifies a range of jointing methods for connecting low alloy steel tubes and steel tubes and fittings for use with aqueous liquids

Thrown objects test of this Standard addressing essential requirements or other provisions of

fittings and connected appliances installed for supplying potable water

Dimensional standards applicable to products complying with this European Standard

the gases are always used in the gaseous form