Bitumen and bituminous binders. Determination of the tensile properties of bituminous binders by the tensile test method1 Scope This European Standard specifies a method for determining the tensile properties of a bituminous binder, in particular those of a polymer modified bitumen, by means of a tensile test. NOTE The tensile properties, more particularly the tensile stress, the elongation and energy, at the yield point and on fracture, are customarily used as a criterion for assessing the quality of these materials. WARNING The use of this European Standard may

that have strain to fracture less than or equal to 5% and show linear elastic behavior to fracture

with particular emphasis on the scattered neutrons

selected measuring techniques for the detection and identification of nanoobjects

Values that are identified as statistically abnormal at 99 % (outliers) using numerical Cochran’s and Grubbs’ tests lead to the elimination of the laboratory that produced them

It also gives a general procedure to identify the category of any optical devices

The methods of preparation are applicable to a wide variety of combinations of adhesives and materials

4 mm and is transparent

and more for symbols for circuit diagrams

This International Standard specifies general and performance requirements for multilayer pipe systems based on pipes made from thermoplastics and intended to be used for gas supply outdoors

It does not cover safety requirements (see EN ISO 10472‑4)

but they are not useful for the prediction of absolute noise emission values

and specifications and references in other International Standards