44402 EZ-TRACK 18" TERMINAL RERAILER STEEL ALLOY-HOSteel alloy track with black roadbed; 1 card The terminal rerailer is connected via terminal wires to a power pack, which provides current to power the layout. In addition to making power connections, the terminal rerailer is also designed to correct derailments that sometimes occur during normal railroad operations. Rerailers are installed after difficult sections of track (turnouts, crossings, S curves, etc.) where derailments may occur. Also

•Pennsylvania Caboose

It also accommodates locomotives and rolling stock with longer wheel bases

this pocket sized gauge enables you to check all important dimensions on your track and rolling stock as follows:

Replacement wheel sets with needle-point bearings

Set of three trees

can also be used with On30 scale trains

Modeled from AAR track engineering dimensions

II & III units represented in 1st run (Phase IV & other units will come with future runs) •Single front window style for low nose units (Double front window planned for in future runs) •Early high- & later-low style side doors •Road specific details for each model •Different exhaust stacks (depending on roadname) •Road-specific battery box doors on engineer’s side •Road specific air cleaner boxes on rear •Lighted control stand inside cab •Different types of fuel & air tanks (depending upon version)

• There are up to 16 user-selectable horns

in TrainMaster Command Control mode

With its impressive 1

a hinged hood