Gas cylinders. In situ, non-destructive examination and testing of refillable seamless steel tubes of water capacity between 150 L and 3000 L, used for compressed gases Specification1 Scope This British Standard specifies requirements for using a combination of appropriate in situ, Non Destructive Examination (NDE) techniques [e. g. visual examination, Acoustic emission Testing (AT) and Ultrasonic Examination (UE)] when periodically inspecting and testing tubes of seamless steel construction and water capacity between 150 L and 3000 L, used for compressed gases for a further period of service. This British Standard is applicable

This European Standard applies to the inspection and maintenance of bearings designed in accordance with EN 1337‑1

This part of ISO 11608 specifies particular requirements to make needle-based drug delivery systems or NIS (needle-based injection system) accessible for persons with visual impairments

Pneumatic component manufacturers

This International Standard establishes mounting dimensions for cylinders for use at 10 MPa [100 bar1]

these tolerances cover the following ranges:

This European Standard gives simulation and/or test requirements for protection against transient overvoltages of such equipment

Although analysis of samples collected in the course of testing is usually necessary in order to evaluate the sampler performance

the requirement can be considered for exclusion

— General Message (GM) Service: to exchange informative messages between participants

BS EN 61193-1 on Quality assessment systems is useful for:

Electrical power distribution companies

TSE agents