Powerflex Roll Center Adjustment Kit - Mini | Gen 1This is an incredibly simple way to change the roll center of your Gen 1 MINI to increase resistance to body roll and correct suspension geometry on lowered vehicles. Lowering the car will change the angle of the front control arm causing suspension compression at rest. This roll center adjuster kit will restore the original roll center and includes a 5mm spacer for fine tuning different lowering amounts and 17" and larger wheel sizes. Each kit

*This header system is designed to be installed directly into existing OEM mounting points*

73 inch 247 mmLoad at Block Height: 2433 lbs 10822 NWeight: 6

Rear Bar Install: Click Here

All Velt Sport spacers are made from 6061 t6 forged alloy for a strong and reliable product

220°/217° duration @

This is only activated on shifts above 5500rpm

All Autotech Q-Chips are designed with EPA-acceptable levels of emissions in mind

They are NOT the typical skinny barrel

- Moisture & Dust Resistant

(1) Silicone hose

The 181WK 02JB's after 2004 will have a 113mm ring gear inner diameter

causing noise and exhaust heat to fill your engine compartment