Ubiquiti Cloud Key Gen2 and Philips Hue Bridge Rack Mount (Modular)3D Printed 1RU rack mount for the Ubiquiti Cloud Key G2 and Philips Hue bridge. This is part of our ModMount Range, so you can mix and match your parts! NOTE: You will need to pair this with another ModMount item (Like a Blanking Plate) to make a full 1RU Width, screws are included to join the parts. The devices slide into the mount from the front and cables are accessible from the rear. This listing is just for the CloudKey Hue Mount, other photos

to maximize accessibility of the ports on the side of the Raspberry Pi

The Home Assistant Yellow slides into the frame from the back after removing the back plate and the Coral Accelerator slots into the front

3D Printed rack mount that lets you mount your LinkTap Gateway and a RaspberryPi 3B or 4 unit into a Single RU

Also includes an PSU Mounting arm so that you can secure the power brick

3D Printed 2RU rack mount for 3x Intel NUC 12G Pro Tall models

Not compatible with the M4 Mini / Mini Pro) into a Single RU in a SOHO 10Inch Rack

This mount also incorporates as Keystone Socket so you can use a Keystone Jack and Fly lead (Optional Extra) to connect to the LAN port to the front panel

the Router slides into the frame from the front and the Cable Modem is held in place from the Rear via a removable Backplate

BMD Microconverter models supported:

this is to ensure a snug fit that will keep the switch in place

The mount is omni directional

The Mount also incorporates 3 Keystone sockets so you can pass the LAN around to the faceplate