Outback FLEXware 250 - FW250For applications with modest power requirements like cabins, remote communication sites, and backup power systems. The FLEXware 250 accommodates all of the essential protective devices in the smallest possible space at the lowest installed cost. The FW250 enclosure is designed to mount on either or both ends of an OutBack FX inverter. Smaller systems can include both the DC disconnect and AC input output breakers in the same enclosure mounted on just

load share

Simple Installation: Easy to wire between two 12V batteries or between a vehicle harness and a secondary battery – no complex configuration required

For single FX Inverter/Charger systems

Rule 14 (HI) Rapid Shutdown NEC 2014

making them easy to install

Battery Temperature Sensor is included

accommodating significant current loads

1 - SW E-Panel

adapting to seasonal sun angle changes

Brochure (All Disco Models): Download PDF

the load is disconnected from the battery to protect against harmful deep discharges

Suitable for use in low leakage circuits requiring a dielectric constant of 3