Geometrical product specifications (GPS). Length standards. Gauge blocks1 Scope This International Standard specifies the most important design and metrological characteristics of gauge blocks with a rectangular cross section and a nominal length ln ranging from 0,5 mm to 1 000 mm. Limit deviations and tolerances are stated for the calibration grade K and for the grades 0, 1 and 2 for various measuring purposes.

Deviations from the test procedure

4 Detection zone angled to the direction of approach

— the (sensible and latent) energy load and need for heating and cooling

long spinal board

BS 2SP 68 to BS 2SP 71 provides specifications relating to snap head high nickel-copper alloy rivets

Why should you use ISO 15883-6 - Washer-disinfectors employing thermal disinfection

Health and safety officers

and references to IEC 62132-8 and IEC 62132-9 have been added in the new Table A

BS EN 60512-16-3 walks you through the test method of measuring the contact-bending strength of connectors for electronic equipment

— performance requirements for cabling links and channels

Non-optical test methods are given in BS EN 168

• determining the immunity test methods relevant for the electromagnetic environment in which their products are intended to be used